Lid Off
Hold the body and rounded bottom of your refillable applicator in one hand. With the other, give the lid a firm pull—it’s snug on purpose, so don’t be afraid to put some muscle into it.
Open
Hold the body of the refillable applicator firmly in one hand. Locate the two raised lines on the rounded bottom section. Using your other hand, place your thumb and fingers on either side of the rounded bottom, then gently squeeze to pop open the applicator.
Load
Hold the open applicator in one hand and take your Bob Bar in the other. Simply place the Bob Bar into the main body of the applicator. It’s that easy!
Close
Once the Bob bar is loaded into the main body of the applicator, firmly push the rounded bottom section back into the main body of the applicator. The Bob bar is now set at the perfect starting height, ready for you to wash.
Wash
Turn on the shower, wet your body as normal, hold the soap under the water for a couple of seconds and then begin to wash. Small circular movements will activate the bar and bristles to maximise the foaming experience.
Customise
Press the button on the main body of the applicator to release more bar. If you’ve released too much, simply push the bar back into the applicator with your hands to reduce the height. If the button no longer presses, you’re nearing the end of your Bob Bar. Use it until it’s finished, then follow the steps above to refill.
Mount
Make sure the suction cups are securely attached to the back of the shower mount. Firmly press the shower mount onto your clean, dry tile or glass surface. For the best hold, ensure both the surface and suction cups are completely dry—no spit required! To remove or adjust the mount, simply slide it upward to release it from the suction cups.
Drain
To keep your applicator neat and dry when not in use, simply slide it into the shower mount with the bristles facing down. The mount also includes a convenient spot to store your lid when you're not traveling with Bob.
Dry
Before travelling with Bob we recommended using a towel to dry the applicator in order to remove any excess water.
Travel
Simply pop on the lid and your applicator is ready to travel with you.
